Follow the directions below to setup the Gatekeeper. Skip the NAT & PAT steps if you are not using them.
- Run gkconfig.bat. You can find it E:\
\VBROKER\bin - You should start on the MAIN tab
- Put gatekeeper.ior in the IOR File
- Put gatekeeper.log in the Log File
- Change to the EXTERIOR tab
- Put the physical IP address of the server where the Gatekeeper is listening into Exterior Address, this is the IP address of your server running Discoverer Server
- Put the open port in the firewall into Exterior Port, I use port 15000, you must exclude this port on Windows Firewall
- File => Save As
- Save the file as gatekeeper.properties in the following location:
Windows:\Apache\Apache\htdocs\discwb4\applet - Start the Gatekeeper
Ensure that HKEY_LOCAL_MACHINE\Software\Oracle\DCW4_START_GATEKEEPER in the Windows registry is set to 1 & Restart the OracleDiscoverer4i Service in Services to start the Gatekeeper - Ensure a new gatekeeper.ior file was created. It should be in the same location you saved the gatekeeper.properties file, the applet directory. Check the file timestamp. This file contains information that the client applet reads to determine the settings of the gatekeeper.properties.
No comments:
Post a Comment